SN/T 3077.2-2012: Test method of flash point. Modified continuously closed cup tester

Delivery: 9 seconds. Download (and Email) true-PDF + Invoice.
Get Quotation: Click SN/T 3077.2-2012 (Self-service in 1-minute)
Newer / historical versions: SN/T 3077.2-2012

Preview True-PDF

Scope

This Part of SN/T 3077 specifies the determination method of flash point by modified
continuously closed cup tester.
Note: For the substance being tested, the flash point is not a constant physical and chemical
constant. It is related to the instrument design, instrument use conditions, test execution steps.
Therefore, the flash point can only be defined according to the standard test method. There is
no guarantee that the results measured by different methods or different test instruments have a
universally valid correlation.
This Part applies to the determination of the flash point of fuel oil, lubricating oil,
solvent oil, and other liquids; the measurement range is 35 °C ~ 225 °C.
Note: This Part can determine samples with flash points below 35 °C or above 225 °C, but the
precision has not been established.
If the flash point test method specified in the product specification required by the user
is not this method, neither this method nor any other method can replace the specified
method without comparative data and approval by the specification setter.
This Part involves certain hazardous materials, operations, and equipment, but does not
provide recommendations for all safety issues related to this. Therefore, it is necessary
to establish appropriate safety and protective measures and establish appropriate
operating procedures before using the standard. Special hazard warnings are shown in
7.2, 8.5, 10.1.2 warnings.

Basic Data

Standard ID	SN/T 3077.2-2012 (SN/T3077.2-2012)
Description (Translated English)	Test method of flash point. Modified continuously closed cup tester
Sector / Industry	Commodity Inspection Standard (Recommended)
Classification of Chinese Standard	E30
Classification of International Standard	75.080
Word Count Estimation	12,135
Quoted Standard	ASTN D93; ASTM D4057; ASTM D4177; ASTM D6450; ASTM D6708; ASTM E300
Adopted Standard	ASTM D7094-2004, IDT
Regulation (derived from)	National Quality Inspection (2012) 237; industry standard filing Notice 2012 No. 9 (No. 153 overall)
Issuing agency(ies)	General Administration of Customs
Summary	This standard specifies the continuous improvement Closed Cup Flash point method. This standard applies to fuel oil, lubricating oil, solvents, oils and other liquids Determination of flash point, the measurement range of 35��C ~ 225��C.